mrgoodwrenchns
Senior Member
Living life a 1/4 mile at a time.
Posts: 192
|
Post by mrgoodwrenchns on Oct 28, 2010 11:44:39 GMT -4
i run a fwd gm platform (monte carlo) and am seriously considering switching to a bfg drag radial next year to eliminate tire spin.anything i should do or basically "plug-n-play"?The car is basically stock with tweaking but i was always concerned about cv shafts as i drive the car there from the kentville area.i am told my front end is bullet proof from a stock configaration.I assume burnouts would be necessary to heat the tires or i might as well run street tires.Any suggestions would be helpful as I am still learning. thanks Ian
|
|
|
Post by sam on Oct 28, 2010 15:10:49 GMT -4
Ian, I would check on axles, just to be safe as starting line launch will be improved therefore adding more strain on the factory components. Burnout will be a must with the radials in order to gain the full benefits of them.
Sam
|
|